Operation
CheckTire Pressures
Tire pressure should be checked periodically, and
maintained at the levels shown in the chart. Note that these
pressures may differ slightly from the "Max Inflation"
stamped on the side-wall of the tires. The pressures shown
provide proper traction, improve cut quality, and extend tire
life.
Tire
Pressure
Front
25 psi (1,72 bar)
Rear
15 psi (1,03 bar)
Figure 4. Checking Tire Pressure
Pushing the Mower By Hand
NOTICE
DONOTTOW MOWER
Towingthe units will causehydraulic pumpand wheel
motor damage. De nat use another vehicle to push or
pull this unit.
1. Disengagethe PTO,engage the parking brake, turn the
ignition OFEand remove the key.
2. Locate the transmission release levers (A, Figure 5) by
the rear wheels of the unit.
3. To disengagethe pumps (free-wheel position), pull both
transmission releaselevers back and out so they lock in
the disengaged(free-wheel) position.
4. Disengagethe parking brake.
The unit can now be pushed by hand.
5. After moving the unit, re-engagethe pumps (drive
position) by pulling the transmission releaselevers
rearward and inward to releasethem from the
disengaged position and then allow them to move to the
engaged (drive) position.
I
t
I
J
Figure 5. Transmission ReleaseLevers (LH Shown
A. Transmission ReleaseLevers
B, Engaged Position (Drive Position)
C. Disengaged Position (Free-Wheel Position)
,/
//
/
14
www.SnapperPro.com