G0514X Inventory - Grizzly G0514X Owner's Manual
Extreme series bandsaw
Hide thumbs
Also See for G0514X:
- Owner's manual (96 pages) ,
- Parts breakdown (6 pages) ,
- Owner's manual (92 pages)
Table of Contents
Advertisement
G0514X Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
crate contents (figure 10 & 11):
A. Bandsaw (not shown) ................................. 1
B. table ........................................................... 1
c. Miter gauge ................................................ 1
D. Back square tube ...................................... 1
E. resaw Fence ............................................. 1
f.
Front rail ................................................... 1
G. Fence assembly ......................................... 1
hardware and Tools (not shown):
•
Bandsaw Blade 6 tpi hook 143" ................1
•
eye Bolt M10-1.5 (may be installed) ............1
•
Flat Washers 8mm (table, Fence) ..............5
•
lock Washers 8mm (table) ........................4
•
hex Bolts M8-1.25 x 16 (table) ...................4
•
hex Bolt M8-1.25 x 90 (pos. stop) ..............1
•
hex nuts M8-1.25 (pos. stop, Fence) .........2
•
table pin......................................................1
•
table insert ..................................................1
•
Cap screws M6-1 x 16 (Fence) ...................2
•
hex Bolts M6-1 x 20 (Fence) .......................2
•
Fence handle M8-1.25 x 22 (Fence) ...........1
•
lock Washers 6mm (Fence) .......................2
•
Flat Washers 6mm (Fence) .........................2
•
rail pad M6 x 18 (Fence) ............................1
•
hex nut M6-1 (Fence) .................................1
•
lock handle M8-1.25 x 44 (Fence) .............1
•
Moving plate (Fence)...................................1
•
hex Wrench 5mm & 8mm ..................... 1 ea
•
open end Wrench 10 x 13mm ....................1
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
Qty
figure 10. Bandsaw components.
Qty
figure 11. Fence components.
B
d
F
C
e
d
g
-15-
Advertisement
Table of Contents
