G0514X, -X2, & X2B Power Connection; G0514X3 Power Connection - Grizzly G0514X Owner's Manual

G0514X, -X2, & X2B
power connection
After you have completed all previous setup
instructions and circuit requirements, the machine
is ready to be connected to the power supply.
To avoid unexpected startups or property dam-
age, use the following steps whenever connecting
or disconnecting the machine.
connecting power
1. Turn the machine power switch OFF.
2. Insert the power cord plug into a matching
power supply receptacle. The machine is
now connected to the power source.
figure 44. Connecting power.
Disconnecting power
1. Turn the machine power switch OFF.
2. Grasp the molded plug and pull it completely
out of the receptacle. Do not pull by the cord
as this may damage the wires inside.
figure 45. Disconnecting power.
G0514X/-X2/-X2B/-X3 (Mfg. Since 2/12)
G0514X3 power
connection
Before the machine can be connected to the
power source, an electrical circuit and connec-
tion device must be prepared per the POWER
SUPPLY section in this manual; and all previous
setup instructions in this manual must be com-
plete to ensure that the machine has been assem-
bled and installed properly. The disconnect switch
installed by the electrician (as recommended) is
the primary means for disconnecting or connect-
ing the machine to the power source.
connecting to power Source
Move the disconnect switch handle to the ON
position, as illustrated below. The machine is now
connected to the power source.
figure 46. Connecting power to machine.
Disconnecting from power Source
Move the disconnect switch handle to the OFF
position, as illustrated below. The machine is now
disconnected from the power source.
Note: Lock the switch in the OFF position to
restrict others from starting the machine.
figure 47. disconnecting power from machine.
lock
-29-