Important Safety Instructions - Sansui SLED1980 Owner's Manual

iMPORTANT SAFETY iNSTRUCTiONS
1) Read these instructions.
2) Keep these instructions.
3) Heed allwarnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean onlywith dry cloth.
7) Do not block any ventilation openings, hstall in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifiers) that produce heat.
9) Do not defeat the safety purpose of the pomarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience
receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specified by the manufacturer.
12) Use only with cart, stand, tripod, bracket, or table specified by the manufacturer,
or sold with the apparatus. When a cart is used, use caution when moving the
cart/apparatus combination to avoid injury from tip-over.
13) Unpmugthis apparatus during mightning storms or when unused for mongperiods of time.
14) Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
15) Apparatus should not be exposed to dripping or splashing, and objects filled with liquids, such as
vases, should not be placed on the apparatus.
16) An outside antenna system should not be located in the vicinity of overhead power lines or other
electric light or power circuits, or where it can fall into such power lines or circuits. When installing an
outside antenna system, extreme care should be taken to keep from touching such power lines or
circuits, as contact with them might be fatal.
17) Do not overload wall outlets and extension cords, as this can result in a risk of fire or electric shock.
18) Do not push objects through any openings in this unit, as they may touch dangerous voltage points
or short out parts that could result in fire or electric shock. Never spill or spray any type of liquid into
the unit.
19) If an outside antenna or cable system EXAMPLEOFANTENNAGRDUND_NGASPERTHENATIONALELECTRICAL
iS connected to the unit, be sure the
antenna or cable system is grounded ANTENNA LEAD INWIRE
to provide some protection against f
voltage surges and built-up static ANTENNA
charges, Section 81 0 of the National DISCHARGE UNIT
Electrical Code, ANSI/NFPA 70, provides
(NEC SECTION 810-20)
information with respect to proper GROUNDING CONDUCTORS
grounding of the mast and supporting (NEC SECTION 810-21)
structure, grounding of the lead-in NEC-NATIONALELECTRtCALCODE
_
POWER SERVICEGROUNDING
ELECTRODE SYSTEM
wire to an antenna discharge unit, size $2898A (NEC ART250. PART H)
of grounding conductors, location of
antenna discharge unit, connection to
grounding electrodes, and requirements for the grounding electrode.