Information Codes - Samsung WF209ANW User Manual

troLAbe hootncj
INFORMATION CODES
Information codes may be displayed to help you better understand what is occurring with your Washer.
Unbalanced load prevented your
Washer from spinning.
Door is unlocked when Washer is
running.
Door is open when Washer is
running.
Your Washer failed to lock the
door.
Your Washer has tried to fill but
has not reached the proper water
level.
Redistribute the load, press the Start/Pause
Button.
Press the Power button to turn off your Washer,
then restart the cycle. If the code reappears, call
for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Close the door tightly and restart the cycle.
If the code reappears, call for service.
Call for service.
r:i zz ¸
ii ¸ q :: :
III i iii ii ii iii
The door will not unlock.
r,"
Motor not running properly.
Your washer is not draining.
It can also mean that the unit
senses a small clog while draining.
Your Washer has tried to fill but
was unsuccessful.
The hotJco,d water hose
connection is not correct.
Problem with control.
Restart the cycle by pressing the Start/Pause
Button.
Call for service
Electric service was lost when
Washer was running.
A fault is detected in the water
level sensor.
Jammed Key.
r Motor speed sensor problem.
i_-1i2
I Temperature sensor problem.
i_-i2
Make sure the door is firmly closed.
Push the Power button to turn off your Washer,
then turn it on again. If the code reappears, call
for service.
Restart the cycle pressing the Start/Pause
Button. If the code reappears, call for service.
Before calling for service, check the following.
1) Turn off the unit and turn it on again.
2) Select only the Spin Cycle.
3) Press the Start/Pause to drain the water.
If it still does not drain, call for service.
Make sure the water faucets are open all the
way. Check for kinked hoses.
Check the inlet screens on the fill hoses.
Please connect the hot/cold water hose
connection correctly.
Call for service.
Call for service
Restart the cycle.
If the code reappears, call for service.
Restart the cycle.
If the code reappears, call for service.
20 troubleshooting
WF209ANW-02440F EN.indd 20 2009-01-20 L._}_._ 4:05:18