Table of Contents
Advertisement
C@nnect @ns
Setup
Step 3: Configuring
for a VCR
1.
If your TV is cnnnected
to a VCR, press OK (a screen appears
renfinding
you to connect your G-LINK cable to your TV and vCR).
If it is not, highlight NO and press OK.
2.
[se
tile up and down arrow buttons to highlight the brand of your VCR that
is connected
to the TV and press OK.
It your brand isn't listed, highlight NOt Listed and press OK.
,
Tune
your VCR lo channel
02. Next,
turn OFF your VCR. When
you
complet*,
these
steps,
press
OK to begin
testing.
Important Note: When code testing is in progress, don't touch your TV, VCR, or
any of the remote controls for these products.
4,
Look at tile front of your VCR. If your VCR turned on automatically
and
g
•
changed
to channel 09, the test _as successful.
Highlight
Yes and
press OK.
If your VCR didn't change
to channel 09, you can either choose _\'bor Test
this code c(gain.
.
.
7
It you think your T'_ or remntes
might have been tnuched during the test,
tune your VCR to channel 02, turn ott your VCR and highlight
78st this
code again.
If you don't think the test was interrupted,
highlight A'O.Tune your _ CR to
channel 02 and turn oil your VCR. Press OK (tile GLIDE Plus+ system starts
testing another set ot codes.)
Keep Ik>llnwing the previous
instructions
until the VCR finds tile
correct cnde.
Chapter
I
19
Advertisement
Table of Contents
