Table of Contents
Advertisement
C@nnect @ns
Setu@
3_
Highlight
file channel
to which
you have
to tune your TV in order
to see
cable
programming,
and press
OK (a screen
appears
reminding
you to
connect
your G-LINK cable
to your TV and cable
box).
Notes: Channel 03 is the most common
Choose Videol/AUX if your cable box is connected to your TV with audio/video
cables instead of a coaxial cable. Go to page 7 for pictures of these cables.
4.
Highlight your brand of cable box, and press OK.
If your brand isn't listed, highlight NOt Listed and press OK.
5_
Make
sure your cable box is on.
Tune
tile cable
box to channel
02 (use
the remow
control
that came
with
your cable
box, or press
tile channel
buuons
on tile cable
box).
Press
OK (tile G{IDE
Plus+ system
starts testing
codes).
Important Note: When code testing is in progress, don't touch your TV,VfiR, cable
box or any of the remote controls for these products.
6_
Look at your cable box. If it is still on and changed to channel 09, tile test
was successl\_l. Highlight
Yes, and press OK ($7t?P3:
Cot_/l_4z_r/t_/4jbra VCR
appear._.
If your cable box didn't change to channel ()9 or turned itself off, you have
two choices: No and 7_._1tbi._ code c(gain.
7_._ttbL_ code c(gain: If you think the TV, the cable box, or any of the remote
controls might have been touched
or/)umped
during tile test, highlight
Test
tbi._ codt, c(gain and press OK (tile GUIDE Plus+ system runs the same set of
codes).
No: If you don't think the test *x.as interrupted,
highlight
No and press OK
(G{ IDE Plus+ syswm tests tile next code).
Repeat tile previous instructions
until the TV I]nds tile correct cable box
code. Follow the instructions
on tile screen.
Note: If the TVcan't find your cablebox
code, a troubleshooting
checklistappears.
Carefully
review eachchecklistand follow the instructionson the screen.
18
Chapter
I
Advertisement
Table of Contents
