Configure Wpa-Personal (Psk) - D-Link DIR 601 - Dlink Wireless N 150 Home Router Product Manual

Secton  - Securty
It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish
wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to
the added overhead.
1..Log into the web-based configuration by opening a
web browser and entering the IP address of the router
(192.168.0.1). Click on. Setup. and then click.Wireless.
Settings on the left side.
2. Next to Security Mode, select WPA-Personal.
3. Next to WPA Mode, select Auto, WPA2.Only, or.WPA.Only.
Use Auto if you have wireless clients using both WPA and
WPA2.
4. Next to Cypher Type, select TKIP.and.AES, TKIP, or AES.
If you have wireless clients that use both types, use TKIP.
and.AES.
5. Next to Group Key Update Interval, enter the amount of time
before the group key used for broadcast and multicast data
is changed (3600 is default).
6. Next to Pre-Shared Key, enter a key (passphrase). The key
is entered as a pass-phrase in ASCII format at both ends of
the wireless connection. The pass-phrase must be between
8-63 characters.
7. Click Save. Settings to save your settings. If you are
configuring the router with a wireless adapter, you will lose connectivity until you enable WPA-PSK on your adapter
and enter the same passphrase as you did on the router.
D-Lnk DIR-601 User Manual

Configure WPA-Personal (PSK)