Troubleshooting - Zanussi ZWGB 7140 K User Manual

1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Remove the drain hose from the rear sup-
port and unhook it from sink or spigot

Troubleshooting

The start of the appliance does not occur or it
stops during operation.
First try to find a solution to the problem (refer
to the table). If not, contact the service centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with water.
Problem
The appliance does not
start.
The appliance does not
fill with water.
www.zanussi.com
Make sure that the mains plug is connected in the mains socket.
Make sure that the appliance door is closed.
Make sure that there is not a damaged fuse in the household fuse box.
Make sure that the button Start/Pause has been pressed.
If the delay start is set, cancel the setting or wait for the end of the countdown.
Make sure that the programme knob is in the correct position.
Deactivate the Child Lock function if it is on.
Make sure that the water tap is opened.
Make sure that the pressure of the water supply is not too low. For this information,
contact your local water authority.
Make sure that the water tap is not clogged.
Make sure that the filter of the inlet hose and the filter of the valve are not clogged.
Refer to 'Care and cleaning'.
5. Put the ends of the drain and inlet hose in
a container. Let the water flow out of the
hoses.
6. When no more water flows, install the in-
let hose and the drain hose again.
Warning! Make sure that the temperature
is more than 0 °C before you use the
appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
•
- The appliance does not drain the wa-
ter.
•
- The appliance door is open or not
closed correctly.
Warning! Deactivate the appliance before
you do the checks.
Possible solution
15