Do you have a question about the ZWG1100M and is the answer not in the manual?
Questions and answers
MARY NIGHTINGALE
February 18, 2025
does this model have an invertor motor
1 comments:
Mr. Anderson
February 18, 2025
The document mentions that the Zanussi ZWG1100M washing machine uses a Welling HXGK1I.13 motor but does not specify whether it is an inverter motor. Therefore, it cannot be determined from the provided information.
This answer is automatically generated
MARY NIGHTINGALE
February 18, 2025
The machine began to stop somewhere mid spin cycle, and gave the beeps to say it was done. The washing was wet and had to be put back on spin. This happened about 4 times in the last few months.
I checked the filter, it was clean, nothing obvious in the drum area by the seal so I tipped it on its side to access underneath. There are no kinks in the outlet hose, and no blockages. Water enters the machine with no issues.
When I plugged it back even though the dial was on 0, so should have been off the whole panel was lit up, and the washer had set itself on a 90 degree wash.
I turned it off again at the mains, left it from 5 mins then tried it. Again the dial was at 0 but the whole panel was lit, and the only way to turn it off was to set the dial on intensive, as this shut the lights off.
It is as though all the pcb connections have been taken off and randomly put back.
At the moment it is set on intensive, ( this seems to turn it off )
I know Zanussi do not make this model now, but which model sold today is the closest to it.
Any work around or fix will be greatly appreciated
Need help?
Do you have a question about the ZWG1100M and is the answer not in the manual?
Questions and answers
does this model have an invertor motor
The document mentions that the Zanussi ZWG1100M washing machine uses a Welling HXGK1I.13 motor but does not specify whether it is an inverter motor. Therefore, it cannot be determined from the provided information.
This answer is automatically generated
The machine began to stop somewhere mid spin cycle, and gave the beeps to say it was done. The washing was wet and had to be put back on spin. This happened about 4 times in the last few months. I checked the filter, it was clean, nothing obvious in the drum area by the seal so I tipped it on its side to access underneath. There are no kinks in the outlet hose, and no blockages. Water enters the machine with no issues. When I plugged it back even though the dial was on 0, so should have been off the whole panel was lit up, and the washer had set itself on a 90 degree wash. I turned it off again at the mains, left it from 5 mins then tried it. Again the dial was at 0 but the whole panel was lit, and the only way to turn it off was to set the dial on intensive, as this shut the lights off. It is as though all the pcb connections have been taken off and randomly put back. At the moment it is set on intensive, ( this seems to turn it off ) I know Zanussi do not make this model now, but which model sold today is the closest to it. Any work around or fix will be greatly appreciated