What To Do If; Machine Settings - Electrolux EDE 37100W User Manual

Cleaning the door
Clean periodically the interior part of the door
to remove any fluff. Accurate cleaning en-
sures correct drying.
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents may
form a barely visible lining on the inside
of the drum. The degree to which the
laundry has been dried is then no longer
detected reliably. The laundry is damper

What to do if ...

Problem
Dryer does not work.
Drying results unsatisfactory.
Loading door does not close.
Drying cycle ends shortly after
programme starts.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically.

Machine settings

BUZZER SIGNAL permanent on/off
1. Turn the programme selector to any pro-
gramme.
Clean operating screen and housing
Possible cause
Mains plug is not plugged in or
fuse is not working correctly.
Loading door is open.
Have you pressed the START
PAUSE button?
Wrong programme selected.
Fluff filter clogged.
Overloading of laundry.
Ventilation slots covered up.
Residue on inside surface of
drum or drum ribs.
Conductance of water at instal-
lation site differs from standard
setting of machine.
Filter not in place.
Not enough washing loaded or
washing loaded is too dry for se-
lected programme.
Filter clogged.
Load volume too big.
Laundry insufficiently spun.
2. Press simultaneously theDELICATE and
than expected when removed from the
dryer.
Use a standard domestic cleaner (e.g.
vinegar-based cleaner) to wipe down the
inside of the drum and drum ribs.
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the op-
erating screen and housing.
Plug in at mains socket. Check
fuse in fuse box (domestic in-
stallation).
Close loading door.
Press the START PAUSE button
again.
Select a different programme
the next time you dry (see "Pro-
gramme chart" chapter).
Clean fluff filter.
Observe recommended loading
volumes.
Uncover ventilation slots.
Clean inside surface of drum
and drum ribs.
Re-programme standard setting
for degree of drying (see 'Pro-
gramming options' chapter).
Install filter into place.
Select time programme or high-
er drying level (e.g. EXTRA DRY
instead of CUPBOARD DRY).
Clean filter.
Reduce load volume.
Laundry must be adequately
spun.
TEXTILE buttons and hold down for ap-
prox. 5 seconds.
electrolux 9
Remedy