Edimax PT-31E Quick Installation Manual page 6

Step 8:
Insert the DI/DO signal cable(s) into
the DI/DO port. If you do not have
DI/DO accessories, you can skip this
step.
Step 9:
Connect the power adapter to the
network camera, then plug the
power adapter into a wall socket.
The camera's LED lights should light
up after a few seconds, and the
camera will test its pan and tilt
motor within 1 minute. Please do
not obstruct the network camera
while it is testing its pan and tilt
motor.
Step 10:
If you need to set up a wireless
connection, please attach the
wireless antenna to the IP camera
and configure through a wired
connection. (PT-31W only)
5