Edimax PT-31E Quick Installation Manual page 12

Method 2: PIN CODE SETTING
Step 1: Power on the wireless AP and the wireless network camera. Wait for 1
minute for both devices to be up and running.
Step 2: Open a web browser and login to the wireless server. Go to the
wireless/WPS setting page.
Step 3: Open web browser and login to the wireless network camera. Go to
the network/Wireless setting page and locate Wi-Fi Protected Setup (WPS)
item.
Step 4: Please enter the corresponding pin code of each device, on both pages
in the field "Configure via Pin Code" – as shown below. Then push the "Start
PIN" button.
Step 5: Wait for 30 seconds. When the network LED of the camera is blinking,
a WPS connection has been successfully established
Step 6: If you have more than 1 camera, repeat steps 2 - 5 for each additional
camera.
IP Camera Page
AP Setting Page
11