Assembly/Pre-Operation; Tools Required For Assembly; To Remove Riding Mower From Carton; How To Set Up The Riding Mower/Install Steering Column/Install Seat - Weed Eater One WE261 Operator's Manual

Your new riding mower has been assembled at the factory with the exception of those
parts left unassembled for shipping purposes, To ensure safe and proper operation of your
riding mower all parts and hardware you assemble must be tightened securely. Use the
correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly
easier, Standard wrench sizes you need
are listed below..
(1) 3/4" wrench
(!) I/2" wrench
(!) Utility knife
(1) Tire pressure gauge
When right or left hand is mentioned in
this manual, it means when you are in the
operating position (seated behind the steer-
ing wheel).
TO REMOVE RIDING MOWER FROM
CARTON
UNPACK CARTON
t. Cut along dotted lines on all four panels
of carton, Remove carton and top frame
as one unit.
2. Remove packing materials from riding
mower.
NOTE: Only cut carton with a short blade
utility knife, a long blade or saw can puncture
tires on unit.
HOW TO SET UP YOUR RIDING
MOWER
iNSTALL STEERING COLUMN
1, Insert steering shaft into mount and se-
curely fasten with bolt, washer, and nut
provided,
2. Insert pin into hole in steering shaft,
3. Slide plastic cover over steering shaft
and into position,
Shaft
Plastic Cover
4. Slide steering shaft protective foam cover
over shaft,
5. Position front wheels of the riding mower
so they are pointing straight forward°
Foam Cover
Steering Shaft
6. Remove steering wheel adapter from
steering wheel and slide adapter onto
steering shaft.
7. Press steering wheel into position on
shaft, install large washer, and tighten
nut securely,
8. Snap steering wheel insert into center of
steering wheel securely,
INSTALL SEAT
!. Pivot seat upward and remove from the
cardboard packing. Remove the card-
board packing and discard°
2. Place seat on seat pan so head of shoul-
der bolt is positioned over large slotted
hole in pan.
3o Push down on seat to engage shoulder
bolt in slot and pull seat towards rear of
riding mower.
Pin
Steering
Shaft
Mount
Seat
Bolt Seat
Bolt