Interlocks And Relays; To Replace Fuse; Engine - Weed Eater One WE261 Operator's Manual

1. Lift s eat forbolt a ccess.
2. Disconnect BLACK battery cable t hen
RED battery cable.
3, Remove battery bracket bolt.
4. Install new battery with terminals facing
totheright, and away
f rom seat as
shown,
5. Reinstall battery bracket and bolt.
6. First connect RED battery cable to posi-
tive (+) battery terminal.
7. Connect BLACK grounding cable to
negative (-) battery terminal
Fender
Battery
Battery
Bracket
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
riding mower to run poorly, stop running, or
prevent it from starting.
• Check wiring, Make sure all wiring and
connectors are secure.
TO REPLACE FUSE
Replace with 4 amp, or 5 amp. automotive
type plug-in fuse. The fuse holderis located
underthe fender.
ENGINE
Your engine speed has beenfactory set. Do
not attempt to increase engine speed or it
may result in personal injury, If you believe
that the engine is running too fast or too slow,
take your riding mower to a qualified service
center for repair and/or adjustment.
Your carburetor is not adjustable. If your
engine does not operate properly due to
suspected carburetor problems, take your
riding mower to a qualified service center
for repair and/or adjustment.
IMPORTANT: Never tamper withthe engine
governor, which isfactory set for proper en-
ginespeed. Overspeeding the engine above
the factory high speed setting can bedanger-
ous. If you think the engine-governed high
speed needs adjusting, contact a qualified
service center, which has proper equipment
and experience to make any necessary
adjustments,
23