Storage; Data Tag; Protecting The Pump; Preparing The Unit For Storage - Troy-Bilt 020242-4 Operator's Manual

Storage
Data tag information is very important if you need help from
our Customer Service Department or an authorized service
dealer,
, The data tag (Figure 17) is located on the base of the
pressure washer. For future reference, please copy the
model revision, and serial number of the pressure washer
in the space below,
Protectin_ the Pump
To protect the pump from damage caused by mineral
deposits or freezing, use PumpSaver to treat pump.This
prevents freeze damage and lubricates pistons and seals.
NOTE: PumpSaver is available as an optional accessory. It is
not included with the pressure washer. Contact the nearest
authorized service center or visit your local Lowe's store to
purchase PumpSaver.
MODEL ]_,_
REV NO ]_
SERIAL ].,_
PSi
GPM
]
]
Copy Model
Number Here
_Copy Revision
Here
Copy Serial
Number Here
PREPARmNG THE UNmT
FOP, STORAGE
VVater should not remain in the unit for long periods of
time. Sediments or minerals can deposit on pump parts and
"freeze" pump action. If you do not plan to use the pressure
washer for more than 30 days, follow this procedure:
I. Flush detergent
siphoning
tube
by
placing filter into a
pail of clean water while running pressure washer in
low pressure mode. Flush for one to two minutes.
2. Shut off engine and let it cool, then remove
high
pressure and garden hoses. Disconnect spark phg wire
from spark plug.
3. Empty pump of liquids by pulling engine recoil handle
about 6 times.This
should
remove most
liquid in pump,
4. Use pump saver to prevent corrosion build up and
freezing of pump.
5. Store unit in a clean,
dry
area.
• Failure so do so will permanently damage your pump and
render your unit inoperable.
, Freeze damage is not covered under warranty.
CAUTION
AJways wear eye pro_ecdon when using PumpSaven
• Pro_ec_ surfaces from dripping PumpSaven
To use PumpSaver, make sure the pressure washer is
turned off and disconnected from supply water. Read and
follow all instructions and warnings given on the PumpSaver
container.
NOTE: If PumpSaver is not available, draw RV antifreeze
(nonoalcohol) into the pump by pouring the solution into a
3ofoot section of garden hose connected to inlet adapter
and pulling recoil handle twice,
STORmNG THE ENGmNE
See the engine operator's manual for instructions on how
to properly prepare the engine for storage.