Maintenance; Specifications; General Maintenance; Pressure Washer Maintenance - Troy-Bilt 020242-4 Operator's Manual

SPECmFICATIONS
Max Outmet Pressure ..................... 3000 psi
Max Flow Rate .......... 2.8 gallons per minute (gpm)
Detergent Use detergent approved for pressure washers
Water Supply ................ Not to Exceed IO0°F
Automatic Coo[ ............. Will cycle when water
Down System reaches 125°° 155°F
Shipping Weight ........................... 95 Ibs.
GENERAL MAINTENANCE
RECOMMENDATIONS
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence.To
receNe full value from the warranty, the operator must
maintain the pressure washer as instructed in this manual.
NOTE:
Should you have questions about rephcing
components on your TroyoBik pressure washer, please caI[
[ =888=6 [ [ =6708 for assistance.
° Some adjustments wH[ need to be made periodically to
properly maintain your pressure washer. Check the spray
gun and nozzle extension assembly for wear.
o All maintenance in this manual and the engine operator's
manual should be made at least once each season,
Once a year you should clean or replace the spark
plug,
clean or replace the air fiker.A new spark plug and clean
air fiiker assure proper fueloair mixture and help your
engine run better and last longer. Please refer to your
engine operator's manual for more details.
If equipped with inflatable tires, keep the air pressure at
the value maH<ed on the tire or within [ 5 and 40 psi.
Before Each Use
I. Check engine oil level.
2. Check water inlet screen for damage.
3. Check in4ine filter for damage.
4. Check high pressure hose for leaks.
5. Ched< chemical injection hose and filter for damage.
6. Check spray gun and nozzle extension assembly for
leaks.
7. Rinse out garden hose to flush out debris.
PRESSURE WASHER
MAINTENANCE
Check
and Clean Inlet
Screen
Examine the screen on the water inlet. Clean it if the
screen is clogged or replace it if screen is damaged.
_h Pressure Hose
The high pressure hose can develop leaks from wear,
kinking, or abuse. Inspect the hose each time before using
iL Check for cuts, leaks, abrasions or bulging of cover,
damage or movement of couplings. [f any of these
conditions exist, replace the hose immediately.
WARNING
NEVER repair high pressure hose, Replace it.
Replacement hose rating MUST exceed maximum pressure
rating of unit,
ent Siphonin Tube
Examine the filter on the detergent tube and clean if
clogged.The tube should fit tightly on the barbed fitting.
Examine the tube for leaks or tears, Replace the filter or
tube if either is damaged.
Check Gun
and
Nozzle Extension
Examine the hose connection to the spray gun and make
sure it is secure.Test the trigger by pressing it and making
sure it "springs back" into place when you release it. Put
the trigger loci< in the ON position and test the trigger.You
should not be able to press the trigger.
Check In-Line
Filter
Refer to Figure 14 and service the in:line filter if it
becomes clogged, as follows:
Nozzle Extension