Advertisement
Available languages
Available languages
Safety
2
READ AND
FOLLOW
SAFETY INSTRUCTIONS!
,_
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for
one of the following signal words and be alert to the
potential for personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if
ignored.
I_'WARNINGIwarns about hazards that can cause serious
personal injury, death or major property damage if
ignored.
1_ CAUTION[warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which
are important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
ELECTRICAL
SAFETY
[_WARNING
Icapadtor
voltage may be hazardous. To
discharge motor capacitor, hold insulated handle screw-
driver BY THE HANDLE and short capacitor terminals
together. Do not touch metal screwdriver blade or
capacitor terminals. If in doubt, consult a qualified elec-
trician.
GENERAL
SAFETY
I_& OAUTION I DO not
touch
an
operating motor. Modern
motors can operate at high temperatures. To avoid burns
when servicing pump, allow it to cool for 20 minutes
after shut-down before handling.
Do not allow pump or any system component to freeze.
To do so will void warranty.
Pump water only with this pump.
Periodically inspect pump and system components.
Wear safety glasses at all times when working on pumps.
Keep work area clean, uncluttered and properly lighted;
store properly all unused tools and equipment.
Keep visitors at a safe distance from the work areas.
[_i'WARNINGl Pump body may explode if used as a
booster pump unless relief valve capable of passing full
pump flow at 75 psi is installed.
WARNING
Hazardous
voltage.
Can shock, burn, or
cause death.
Ground pump before
connecting
to power
supply. Disconnect
power
before working on pump,
motor or tank.
,_
Wire motor for correct
voltage. See "Electrical"
section of this manual and
motor nameplate.
,_
Ground
motor
before
connecting
to power
supply.
_i
Meet National Electri-
cal Code, Canadian
Electrical Code, and local
codes for all wiring.
_i
Follow wiring instruc-
tions in this manual
when connecting motor to
power lines.
WARNING
Hazardous
pressure!
Install
pressure
relief
valve in discharge
pipe.
Release all pressure on
system before working on
any component.
Advertisement
