Power Control Menu; No Signal Off; No Operation Off; Setup Menu - Sharp Aquos LC-46SE94U Operation Manual

On-Screen Display Menu
= 0 " 0 0 =
Power control setting allows you to save energy.
Example
[ _ Power Control ]
Example
Setup ]
1 Press MENU to display the MENU screen, and then
press _l/il_ to select "Power Control".
2 Press A/T to select a "No Signal Off" or "No
Operation Off", and then press ENTER,
3 Press _/i_ to select "Enable", and then press
ENTER,
4 Press MENU to exit.
When set to"Enable", the power will automaticall shut
down if there is no signal for 15 minutes.
,, Five minutes before the power shuts down, the remaining
time displays every minute.
,, "Disable" is the factory preset value.
,, When a TV program finishes, this function may not operate.
When set to "Enable", the power will automaticall shut
down if there is no operation for 3 hours.
,, Five minutes before the power shuts down, the remaining
time displays every minute.
,, "Disable" is the factory preset value.
FREEZE MENU
0 @
1 Press MENU to display the MENU screen, and then
press _11/1_ to select "Setup".
2 Press A/_' to select a specific adjustment item,
and then press ENTER.
,, When you select "EZ Setup", "CH Setup", "Parental
CTRL" or "Reset",you can enter the 4-digit secret
number here.See page 26 for setting a secret number.
3 Press h,/Y (or _/_) to select the desired setting,
and then press ENTER.
4 Press MENU to exit.
You can run EZ Setup again, even after setting up the
preset channels.
Language: Select from among 3 languages (English,
French and Spanish).
TV Location: Select "Home" or "Store" for the location
where you plan to install the TV.
• If you select "Home", AV MODEis set to "STANDARD".
• if you select "Store", AV MODEis set to "DYNAMIC(Fixed)".
In case no remote control signal is receivedwithin 30
minutes,AV MODE will change to "DYNAMIC(Fixed)"
automatically.
Air/Cable: Make sure what kind of connection is made
with your TV when selecting "Air" or "Cable".
OH Search: Channel auto search makes the TV look for
all channels viewabb in the set area.
,, See "initial Setup" on page 15 for setting each item.
,, If no channel is found, confirm the type of connection made
with your TV and try EZ Setup again.
,, If you select "Analog Search Start" and initiate the channel
search, the CH Memory for Cable Digital will be deleted.
Q- 24