Surround; Auto Vol; Clear Voice; Power Control Menu - Sharp AQUOS LC-26D44E Operation Manual

Menu operations

Surround

Menu Operation: A (page 12)
Surround function allows you to enjoy realistic "live"
sound.
NOTE
• You can also choose surround effects by pressing
SURROUND on the remote control unit.

Auto Vol.

Menu Operation: A (page 12)
Different sound sources, fairly often do not have the
same volume level, for example the changing from
movie to the advertisements. The Automatic Volume
Control (Auto Vol.) solves this problem and equalises
the volume levels.

Clear Voice

Menu Operation: A (page 12)
This function emphasises speech voice against the
background noise for more intelligibility. It is not
recommended for music sources.

Power Control menu

MENU [ Power Control ]
Power Control

No Signal Off

No Operation Off

No Signal Off
Menu Operation: A (page 12)
When set to "Enable" the TV will automatically enter the
standby mode if there is no signal input for 15 minutes.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
NOTE
• When a TV programme finishes, this function may not
operate.
• This function is not available in DTV mode.
No Operation Off
Menu Operation: A (page 12)
When set to "Enable" the TV will automatically enter
the standby mode if no operations are performed for 3
hours.
• Five minutes before the TV enters standby mode, the
remaining time displays every minute.
TV/DTV/AV only
Setup
[Disable]
[Disable]
TV/AV only
TV/DTV/AV only

Power Management

Menu Operation: A (page 12)
When set, the TV will automatically enter the standby
mode.
Item
Off: • No power management
• Factory preset value.
Mode1: • If there is no signal input for 8 minutes, the
TV enters the standby mode.
• Even if you start using the PC and the
signal inputs again, the TV stays in standby
mode.
• The TV turns on again by pressing a on
the TV or B on the remote control unit.
(See page 8.)
Mode2: • If there is no signal input for 8 seconds, the
TV enters the standby mode.
• When you start using the PC and the signal
inputs again, the TV turns on.
• The TV turns on again by pressing a on
the TV or B on the remote control unit.
(See page 8.)

Setup menu

MENU [ Setup ]
Setup

Auto Installation

Programme Setup
Child Lock
Position
WSS
4:3 Mode [Panorama]
Language [English]
Supply Voltage [Off (0V)]
Auto Installation
You can run Auto Installation again, even after setting
up the preset channels.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Auto Installation", and
then press OK.
If you have already set the PIN under "Child
Lock", enter it here.
• See page 17 for setting PIN.
4
Press c/d to select "Yes", and then press OK.
5
You can set language and country the same as
in the initial auto installation. Follow steps 1 and
2 on page 8.
PC only
Option
[On]
TV only
15