Rs-232C Port Specifications - Sharp Aquos LC-46SE94U Operation Manual

Appendix
[] PC control of the TV
* Attach an R3-232C cable cross-lype (commercially
available) to the supplied Din/D-Sub RS-2320 for the
connections.
,,This operation system should be used by a person who is
accustomed to using computers.
[] Communication conditions
Set the RS-2320 communication settings on the PC to
match the TV's communication conditions.
The TV's communication settings are as follows:
9,600 bps
8 bits
None
1 bit
None
[] Command format
EightASCII codes + CR
Command 4-digits Parameter 4-digits Return code
Command 4-digits: Command. The text of four characters.
Parameter 4-digits: Parameter 0 9, x, blank, ?
[] Parameter
Input the parameter values, aligning left, and fill with
blank(s) for the remainder. (Be sure that 4 values are
input for the parameter.)
When the input parameter is not within an adjustable
range, "ERR" returns. (Referto "Response code format".)
Any numerical value can replace the "x" on the table.
[] Communication procedure
Send the control commands from the PC via the RS-
2320 connector.
The TV operates according to the received command
and sends a response message to the PC.
Do not send multiple commands at the same time.
Wait until the PC receives the OK response before
sending the next command.
[] Command table
Commands not indicated here are not guaranteed to operate.
CONTROL ITEM COMMAND PARAMETER
POWER ON COMMAND SETTING RiSiPiW0i i i OFF
i i i, iii oN
POWERSETT_NG PpiWiR,0i i i Powe, O_
_ _ _ _ _ Power On
i i i _ i i i
INPUTSELECTIONA tOGGLE I ITIGID i i i (Toggle)
R/ IjTjVjD 0[ [ [
NPUTI 7 I [A IV [D , [ [ [ ff]putteuNnalnumber(l 7)
_NPUTSELEOT_ONBNPOTI _[NiP[I, 111 0:AUTO, I:V_DEO, 2:GOMPONENT
NPUTS I INIPI3,
ill
0:AUTO, 1 :VIDEO, 2: COMPONENT
AV MODE SELECTION A , V ,Iv1 , D , , , 0: (Toggle)_1: STANDARD, 2: MOVIE, 3: GAME, 4: USER,
[ [ [ l [ [ [ 5: DYNAMIC(Fked), 6: DYNAMIC, 7: PC, 8: xvYCC
VOLUME ViOiLiM, i*i i V°lume (CLC0)
POSITION -I-POSITION H[P [0 iS , [ * [ * [
,POSITION v [P[ois [* [* [
SLOOK C [ L [ O [ K [ * [ * [ Only PC mode (01S0)
SHASE P i H i S i E , i * i * i Only PC mode (6_40)
VISA!MODE WiliDiE i i i 0: (Toggle) [AV], l: Side Bar [AV], 2: S Sttetch [AV]
i i i i i i i 3: Zoom [AV], 4: Stletch [AV], 5: Nou hal [PC]
l l l l l l l 6: Zoom [PC], 7: Stretch [PC],
i i i i i i i 8: Dot by Dot [PC] [AV], 9: Full Screen [AV]
= = = i = = =
MUTE MiUiTiE, [ [ [ 0: (Toggle), 1: On, 2: Off
SURROUND A[C[S[U, [ [ [ 0: (Toggle), 1: On, S: Off
AUDIO SELECTION A
l c I H IA, i
l l (Toggle)
SLEEPTIIVlER O[F[T[IVl [ [ [ O;OFEI:OFFTIMER 30MIN,2:OFF11MER 60MIN
[ [ [ ! [ [ [ 3:OFFTIMER 90MIN,4:OFFTIMER 120MIN
CHANNEL DIRECT DiOiCiH, i*i*i The channel number ofTV
3HANNEL J J J J J J J (1 135)
ANALOG) [ l l I l l l
)]RECT DiAi2iP' 1"1"1" (01009999)
3HANNEL D i C i 2 i U , i * i * i (1 999)
DIGITAL} i i i i i i i
DiCi2iL, i*i*i (0999)
DiSil i °, i*i * i* (o9999)
DIoIIll, l*l*l* <o_sss>
SH UP C [ H [ U [ P [ [ [ The channel number of TV _1
SH DOWN C [ H [ D [W [ [ [ The channel number of%/ _1
CO C [ L [ O [ P [ [ [ (Toggle)
When "?" is input for some
commands, the
present setting
value responds.
[] Response code format
Normal response Problem response (communication
error or incorrect command)
Return code (0DH)
LEiR Ri J
Return code (0DH)
CONTROL CONTENTS
The Power On command lejected
The Power On command accepted
t shifts to standby
%wer On
t input switches by the toggle (It is the same as an input change key)
t input switches to TV (A channel remains as it is (last memory))
t input switches to INPUT1 4NPUT7
_,n input change is also included
_,lthough it can choose now, it i9 toggle operation in inside
[he screen position variable ranges depend on the View Mode or the
_ignal type¸ The ranges can be seen on the position setting screen¸
3: Although it can choose now, it is toggle oper _tion in inside
1 : On(/available when 4:3 signal is being input
5, 8: Only available when 4:3 signal is being input
B: [PC] Available except when UXGA is being input
[AV] Only available when 1080i/p is being input
_: Only available when 720p is being input
_,n input change is included if it is not 7V display
n Air; 2_9ch is effective
n Cable, 1 195ch is effective
DIGITAL Air (Two Par1 numbers, 2 digit plus 2 digit)
DIGITAL Cable _k,_o Par1 numbers, 3 digit plus 3 digit)
font half d DIGITAL CABLE CHANNEL NO (Designate major channel)
DIGITAL Cable (Two Par1 numbers, 3 digit plus 3 digit)
Rear half of DIGITAL CABLE CHANNEL NO (Designate minor channel)
DIGITAL Cable/One Part numbers, 5 digit, less than 10,000)
DIGITAL Cable (One Part numbers, 5 digit, mol÷ than 10,000)
f it is not TV display, it will input switch to 7V (same function as CHA)
f it is not TV display, it will input switch to 7V (same function as CHV)
toggle operation of a closed caption
,, If an underbar (_) appears in the parameter column, enter a space.
,, If an asterisk (*)appears, enter a value in the range indicated in brackets under CONTROL CONTENTS.
,, Any numerical value can replace the "x" on the table.
Q- 48