Sanyo DS25230 Owner's Manual page 9

Cable Television (CATV)
Connect the cable system's 75.Q cable directly to the 75_ antenna input jack on
back of the "IV. A Converter Box may be required to descramble the signals.
UHF/VHF Combination Antenna with 75_ Lead-in Cable
Connect the antenna's 75_ lead-in cable directly to the 75_ antenna input jack
on back of the TV.
UHF/VHF Combination Antenna with 300_ Twin-lead Wire
• Connect the twin-lead wire from the combination UHF/VHF antenna to the
terminals on the antenna adapter (supplied).
• Slide the antenna adapter onto the 75_ antenna input jack on the back of
the TV.
Separate UHF and VHF Antennas with 300Q Twin-lead Wires
• Connect the twin-lead wires from the UHF antenna and the VHF antenna to
a UHF/VHF signal mixer (300_ input/75_ output, not supplied).
• Slide the UHF/VHF signal mixer onto the 75.(2 antenna input jack on the back
of the TV.
POOR SIGNAL RECEPTION
Faulty antenna systems, antenna systems not suited for the area, or antennas
not directed toward the station selected can cause poor signal reception.
NOTE: If you are using a Cable TV system, contact your local Cable Company.
"Snow" or weak picture is the result of either a weak signal or a poor antenna.
"Interference" may be caused by electrical appliances, auto ignitions, CB
radios, etc. Interference of this type is normally temporary.
"Ghosts" or multiple images are signals reflected off mountains or high
buildings.
SNOW INTERFERENCE GHOSTS
9