Samsung DV405 Series User Manual page 25

Time Dry -Time Dry allows you to select the desired cycle time in minutes.
Turn the Cycle Selector dial to Time Dry,then press the Adjust Time up arrow to set the drying
time.
Press the arrow repeate@ to scroll through the time settings.
Quick Dry - Provides a 30 minute drying cycle.
Air Fluff-The Air Fluffcycle tumbles the load in room temperature aL
Refresh - This cycle is best for smoothing out wrinkles and reducing odors from loads
consisting of one to four dry items. In this cycle, a small amount of water is sprayed into the
dryer drum after several minutes of tumbling with heat.
Wrinkle Away - The Wrinkle Away cycle removes wrinkles from clothes stored in closets,
etc. It provides a wrinkle releasevia optimized steam care. You can change the drying time.
(Minimum time :20 minutes) *For best results, load no more than 3 items.
{_ Overloading dryer may yield same
the not the resuJts..
The display window shows the estimated time remaining in the cycle after the Start/
Pause button is pressed. The estimated time remaining may fluctuate as the cycle
progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate.
When your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, "END" appears in the display panel until the dryer door is
opened, the Power, Start/Pause is pressed or about 5 minutes have passed.
If your dryer is paused during a cycle, the indicator lights will blink until the Start/Pause
button is pressed.
Wrinkle Prevent -Wrinkle Prevent provides approximately 180 minutes of intermittent
tumbling in unheated air at the end of the cycle to reduce wrinkling, Press the Wrinkle
Prevent button to activate this feature.
The indicator light above the pad will illuminate when Wrinkle Prevent is selected.
The load is dry, and can be removed at any time during the Wrinkle Prevent cycle.
Mixed Load Bell - The mixed load bell that notifi es you when the average dry level in
a load is damp dry (80 % dried).This lets you take garments that you don't want fully
dried or that dry quickly out of the dryer early while letting others continue to dry.
You can select this function in all Sensor Dry cycles except Wool and Sanitize.
The dry level selections are limited to Normal Dry, More Dry, and Very Dry.
Delay Start : Any cycle can be delayed for up to 24 hours in one-hour increments.
Displayed hour indicates the time at which the cycle will be started (See page 27 for
details.)
My Cycle : Choose your favorite cycle including cycle, temp, dry level option, etc. (See
page 27 for details.)
Rack Dry : Rack Dry is available in the Time Dry cycle. Temperature will be set to Extra
Low only. (See page 29 for details.)
Adjust Time - Time can be added or subtracted from the automatically set times in the
Manual Dry cycles ffime Dry, Quick Dry, Air Fluff cycles).
To add or subtract time from the cycle, press the Adjust Time arrow pad up or down
until the desired time is displayed.
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles, press the
Dry Level button. An indicator light will illuminate next to the desired dryness level.
Press the button repeatedly to scroll through the settings. Larger or bulkier loads may
require the Very Dry or More Dry setting for complete dryness.
The Less Dry setting is best suited for lightweight fabrics or for leaving some moisture
in the clothing at the end of the cycle. Damp Dry is designed to partially dry items. Use
for items that lay flat or hang to dry.
DV405ETPAWR-03021F-03 EN 20120710.indd Sec13:25
operating Instructions, tips 25
2012-07-10 vv 5:30:51
I