Using The Wps Button; Failed Wireless Connection - Samsung UN32F5500 E-Manual

Using the WPS Button
If the router has a WPS push button, you can use it to connect the TV to the router automatically. WPS
automatically configures the SSID and WPA key settings.
Setting Network type to Wirebss automatically displays a list of available wireless networks.
2, Select WPS(PBC) and then press the router's WPS button within two minutes.
3, The TV automatically acquires the SSID and security key settings and connects to the network. A
confirmation message is then shown once a connection is established. Select OK to proceed.
Failed Wireless Connection
Wkeb ss n etwo rk co n n ectio n fai_ ed_ o_" n o wkeb ss rout e r sebct ed,
Go to Network Settings and select the correct router.
U na bb to co nnect to a wkeb ss router
Check the following:
Check that the router is turned on, and if it is, turn it off and on again.
2, Enter the correct security key if required.
_P auto settin9 faibd :_
Perform the following or set the IP address manually from mPSettings.
Make sure that the DHCP server is enabled on the router and unplug and plug the router back in.
2, Enter the correct security key if required.
3, if this does not work, contact your Internet Service Provider for more information.