Reebok 8400C User Manual page 23

PROBLEM: The walking belt slows when waJked on
SOLUTION: a, Use onUya singb-outbt surge suppressor that meets aH of the specifications described on page 10,
b,
C,
ff the waUking beUtis overtightened, treadmHUperfor-
mance may decrease and the waUking beUtmay be-
come damaged, Remove the key and UNPLUG THE
POWER CORD, Using the allen wrench, turn both
rear roller bouts counterclockwise, 1/4 of a turn, When
the waUking beUtis propedy tightened, you shouUd be
abb to Hft each edge of the waUking beUt3 to 4 inches
off the waUking pUatform, Be carefuU to keep the waUk-
ing beUtcentered, Then, pUugin the power cord, insert
the key, and run the treadmill for a few minutes,
Repeat until the walking belt is properly tightened,
If the walking belt still slows when walked on, see the
front cover of this manual,
Rear Roller Bolts
PROBLEM: The walking heft is off-center or slips when walked on
SOLUTION: a,
b,
If the walking belt is off-center, first remove the key
and UNPLUG THE POWER CORD, If the walking
belt has shifted to the Jeft, use the allen wrench to
turn the left rear roller bolt clockwise 1/2 of a turn; if
the walking beJt has shifted to the right, turn the
bolt counterclockwise 1/2 of a turn, Be careful not to
overtighten the walking belt, Then, plug in the power
cord, insert the key, and run the treadmill for a few
minutes, Repeat until the walking belt is centered,
if the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER COBB, Using
the allen wrench, turn both rear roller bolts clockwise,
1/4 of a turn, When the walking belt is correctly tight°
ened, you should be able to lift each edge of the walk-
ing belt 3 to 4 inches off the walking platform, Be
careful to keep the walking belt centered, Then, plug
in the power cord, insert the key and carefully walk on
the treadmill for a few minutes, Repeat until the walk-
ing belt is properly tightened,
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a, With the key in the console, press one of the Incline buttons, While the incline is changing, re-
move the key. After a few seconds, reinsert the key, The treadmill will automatically rise to the
maximum incline level and then return to the minimum level, This will recalibrate the incline,
23