Table of Contents
Advertisement
•
Check to make sure there was a tape in the VCR and the cassette's safety tab was intact.
•
VCR ejects cassette when the end of the tape is reached during a timer recording.
•
Check to make sure VCR Plus+ setup was completed
correctly,
Clock shows incorrect
time or date
•
Power interruption. Automatic
clock set was not turned on or did not work properly. Check time zone and daylight-
savings settings,
•
Make sure VCR or cable box is tuned to channel carrying XDS information.
Time did not adjust
for daylight-saving
time
•
Check to make sure daylight-saving feature is set correctly.
VCR makes noise when
stopped
•
VCR is removing
tape from heads. This is normal. The head cylinder
inside the VCR will continue
to rotate for a few
minutes after you put the VCR in the stop mode.
Will not AUTO CHANNEL
SEARCH active channels
correctly
•
Check to make sure the antenna connections
are secure and correct.
•
Check to make sure the SIGNAL TYPE: CABLE/ANTENNA feature is set correctly.
•
If DETECT AUTOMATICALLY was selected for the SIGNAL TYPE in the AUTO CHANNEL SI=ARCH menu, try using either
CABLE TV or ANTENNA instead.
•
May not be necessary if using a cable box for all channels. Contact your local cable company for more information.
Tape plays back in slow motion
•
PressPLAYto return to normal playback.
Cannot select channels over 69
•
Cable channels over 69 can only be selected if SIGNALTYPE:CABLE/ANTENNAfeature is set to CABLE.
Cassette
with safety
tab removed
does not start to play automatically
•
Check to make sure the AUTO PLAY ON/OFF feature
isset to ON.
TIMER indicator
flashes
•
Check to make sure there is a cassette in the VCR when a timer recording isset.
Time counter
disappears
during searching
•
This is normal.
On-screen
menus appear
in English, French, or Spanish
•
Check LANGUAGE feature.
59
Advertisement
Table of Contents
