Table of Contents
Advertisement
Using the Battery to Power Your Camcorder
The battery must be charged as described on the nextpage
before it can be used the
first time. Initial charging will take approximately
70 minutes.
When fully charged,
the battery should supply about 70 minutes of operating time ,(depending on how much
you use the light, zoom, and pause). Conserve battery power by turning the camcorder
off during recording breaks.
Note: The small marker switch on top of the battery is for use as a personal reminder to help you
remember to recharge the battery. It has no other function.
Reference
Marks
Marker
Switch
BATT.
RELEASE
Button
POWER
Switch
and
Indicator
Attach the Charged Battery
If the DC cable is attached to the
camcorder, remove it before attaching the
battery. Also, install the lithium c!ock
cell before attaching the battery pack.
Details on page 42.
1. Align the reference mark on the
battery with mark on back of
camcorder.
2. Hold the top of the battery flush
against the camcorder and press the
.
bottom of the battery down until it
locks into place.
Place the POWER switch in CAMERA.
The power indicator will light.
Remove
the Battery
Slide and hold BAT7: RELEASE to the
right while removing the battery.
ATTENTION:
The RBRC
seal on the battery
used in your Thomson
Consumer
Electronics
product
indicates
that we are participating
in a
program
to collect
and recycle
Nickel
Cadmium
batteries
throughout
the
United
States.
Please call
1-800-8-BATTERY
for information
or
contact
your local recycling
center.
Ni-Cd
13
Advertisement
Table of Contents
