Table of Contents
Advertisement
Playback
Operation
.
Set the CHANNEL
4CH/3CH
switch
on the RF output
adapter
to
CHANNEL
4CH or 3CH.
2. Turn on the TV, and tune it to the same
channel you selected with the RF
output adapter's CHANNEL
switch.
3. Slide the POWER switch up to turn on
the camcorder.
4. Press the VCR/CAM button to place
the camcorder
in the play mode. The
green VCR indicator will light.
5. Press the PLAY button.
.
• During
playback,
use the playback
features
on [,age 3 7.
Press STOP on the camcorder
when
you are finished.
Viewing What the Camcorder
Is Recording
1. Turn on the TV and tune it to channel
3 or 4. When the camcorder
is used as
a camera, turn the TV's volume down
to prevent a high-pitched
squeal
caused by feedback.
2. Set the CHANNEL 4CH/3CH switch
on the RF output adapter to the same
channel you selected on the TV.
3. Slide the POWER switch up to turn on
the camcorder.
The red CAM
.
Note: When the camcorder
is used as a
camera, turn the TV's volume down to
prevent a high-pitched
squeal caused by
feedback.
Press the REC START/STOP
button
(thumb
trigger), to begin recording.
You can watch what the camcorder
is
seeing (or recording)
on the
TV screen.
indicator
will light.
For normal
TV viewing,
you may
leave
TV.
Disconnect
the adapter's
plug
from
the RF output
adapter
hooked
up to the
the camcorder
or turn
off the camcorder.
Note:
The remote
will also operate
the camcorder.
Press the DISPLAY
button
to have the camcorder's
displays
appear
on the TV
screen.
During
tape copying,
these displays
will be recorded
when they appear
on
the TV screen.
Note to Cable
TV Installer
This reminder
is provided
to call your attention
to Article
820-40
of the National
Electrical
Code (Section
54 of Canadian
Electrical
Code,
Part I), that provides
guidelines
for proper
grounding
and, in particular,
specifies
that the cable ground
shall be connected
to the
grounding
system
of the building
as close to the point of cable entry as practical.
41
Advertisement
Table of Contents
