Table of Contents
Advertisement
Connections
and
Setup
How to Program the Remote
There are two ways to program the remote control: automatic
code search and direct entry.
Component
Buttons
Theseare the buttons you program to operateanother
component.
Using Automatic
Code Search
1.
Turn on the component
you want the remote to operate
(VCR, HD
receiver, etc.)
2.
Press and hold the component
button that corresponds
to the
component
you want the remote to operate
(VCR, HD receiver, etc.).
While you hold down the component
button, press and hold
ON-OFF
(when the red light on the remote turns on, release both
buttons).
Note.. Automatic
Code Search can't be used with the A UX button.
3.
Press PLAY (the red light on the remote starts flashing).
The remote is searching
the first set of component
codes (there are
several sets of codes). If the component
you want to operate
doesn't
turn off automatically
after 5 seconds,
press PLAY again (the red light
starts flashing again as the remote searches
through the next set of
codes).
Continue
pressing PLAY until the component
turns off.
4,
NOTE: If the component
doesn't turn off after you 're pressed the PLAY
button 20 times, the component
can't be programmed.
Press REVERSE and wait 2 seconds. Repeat this step until the
component
turns back on.
5.
To finish, press and hold the STOP button until the red light on the
remote turns off.
16
Chapter
1
Advertisement
Table of Contents
