Table of Contents
Advertisement
Connections
and
Setup
Contents
of the Package
Cinema
,_creen
monitor
Power
cord
Ferrite
cores
RGB cable (Mini D-Sub 15-pin to Mini D-Sub 15- pin connector)
Remote control unit with two AA batteries
User's manual
It is highly recommended
that you have your monitor
installed
by a professional.
If you are installing
the monitor
yourself,
refer to the Reference
section.
NOTE: If you are planning
on attaching
tile floor stand to your monitor (and not the optional wall mount unit) you may
want to use the safety metal fittings (provided)
to give your monitor extra stability.
The safety metal fittings attach to the back of the screen and can then be used to secure the monitor to the wall with strong wire.
Contact your trained, authorized
dealer for professional
installation.
In order to conform
to mandatory
FCC standards,
you must attach the supplied
ferrite cores to both ends of the power
cable (see below).
If you are connecting
a computer
to the monitor, you must attach the ferrite cores to both ends of the DVI cable to meet
FCC standards.
Attaching
the ferrite cores
Set the ferrite cores on the both ends of the DVI cable (supplied),
and one end of the power cable (supplied).
Close the lid
tightly until the clamps click. Use the band
(supplied)
to secure tbe t;errite core.
DVI cable
(not supplied)
band
band
connector
core (small)
core (small)
power cable
(supplied)
band
core (large)
(monitor
side)
6
Chapter
1
Advertisement
Table of Contents
