Table of Contents
Advertisement
Other Infermatien
GUIDE Plus+ System
Problems
(continued)
Program
information
doesn't
download
•
Review your setup information
and make sure it's correct.
Press MENU on the remote and select GUIDE Plus+ Sel/up. Go to page 16
for detailed
instructions
about the GUIDE Plus+ Setup menus.
•
The TV must be off to download
information.
Leave your TV off overnight,
for at least 10 hours, to receive the initial download
for
your area.
•
If you're using a cable box, leave it on so you can receive program
information.
Scheduled
Watch
or Record
doesn't
occur
•
Check Schedule
for timer conflicts.
Go to page 26 for instructions.
•
Make sure the wands of the G-LINK cable are placed in front of the remote sensor(s)
on the component(s).
•
Make sure your VCR is turned
off during
the time you've scheduled
to record a program
because the system turns the VCR on when
it starts recording
(if it's already on when recording
starts, the system will turn it off).
•
Make sure there is a tape in the VCR and that the VCR is connected
properly.
•
Be sure that you set up the VCR in the GUIDE Plus+ Setup menus. If you don't complete
the Config_uringfor a VCR steps successfully,
the Record option won't be available. Go to p. 18 for detailed
instructions.
•
Ifa cable box is attached
to your TV, make sure you set it up correctly
in the GU[DEPlus+Setupmenus.
Go to pages 16-17for
detailed
instructions.
The Remote
Control
Doesn't
Work
•
Something
might be between the remote and the remote sensor on the component.
Make sure there is a clear path.
•
Maybe batteries
in remote
are weak, dead or installed
incorrectly.
Put new batteries in the remote.
•
You might need to drain the remote's microprocessor:
remove batteries
and press the number
1 button for at least 60 seconds.
Release the 1 button,
replace the batteries,
and (if necessalT)
program
the remote again.
Problems
with
V-Chip/Parental
Controls
The rating
limits don't
work
•
You must lock tim settings.
Go to tim TVMAIN
MENU (press MENU on your remote),
select Parental Controls (press 6 on your
remote),
select Lock Parental Control.s (press 6 on your remote).
I don't remember
my password
and I want
to unlock the TV
•
If you forget your password, simultaneously
press and hold MENU on tim television and volume down on the remote for 3 seconds.
Nothing
appears
on the screen, Parental
Controls
simply unlock and you can re-enter a password via Lock Parental Controls.
The V-Chip
won't
let me watch
a program
even though
it's not rated
as violent.
•
Maybe the movie was given an NR (Not Rated) status. After you block movie ratings, you must set NR to Viewseparately
in order to
view movies with an NR rating.
52
Chapter
4
- Quick Links:
- Introduction: Key Features Overview
Hide quick links:
Advertisement
Table of Contents
