Titler - RCA CC4271 User Manual

Titler (continued)
To Create a Title
1. Attach a power source to the
camcorder. Press and hold the small
button on the CAMERA/OFF/VCR
switch while you slide it to CAMERA.
2. Press TITLER to display the titler
graphics in the viewfinder. A flashing
cursor appears.
3. Press EDIT-ADVto move the flashing
cursor to the place where you want to
begin your title.
4. Select the first character for your
title by pressing the + or - button
until the character you want appears
in the viewfinder.
See the chart below for the characters
available.
5. After you have selected the first
character, press EDIT-ADV to move
the flashing cursor to the place where
you want the next character to appear.
6. Repeat steps 4 and 5 until you have
completed the title.
7. When you are finished, press TITLER
to store the title and remove the title
graphics from the viewfinder.
Remember: Be sure to remove the titler
graphics from the viewfinder for normal
recording.
To Correct an Error ..... ...... ...... ...... ...... ...... ...... ......
1. Press TITLER to display the titler
graphics in the viewfinder.
2. Press EDIT-ADV to move the flashing
cursor over the character you want to
correct.
.
Press the + or - button until the
correct character appears.
Note: If you want to delete a character,
press + or - until the blank space appears.
Chart of Characters in Titler's Register
A B C D E F G H I J KL M
N O P Q R ST UVWXY Z
01 23456789? ' /,
- ; : < > ! (BLANK)
36