Autoprogramming Channel Memory; Editing Channel Memory - GE 13GP243 Manual

Operating Features
AutoProgramming Channel Memory
The Channel Memory is the list of TV
channel numbers your "IV will stop on
when you press the CHAN up or down
button. You can program any list of
channels into the channel memory
although your TV is so automatic that
you will probably never need to
manually operate this feature. If you
do, follow the instructions at the right.
1. Connect home anteuna(s) or cable to
your set.
2. Press MENU until SETUP is
highlighted. Press + to select the
SETUP menu.
Editing Channel Memory
Follow these instructions to erase and add
channels.
1. Press MENU until SETUP is high
lighted. Press + to select the SETUP
menu.
The first time you turn on the TV, it
cycles through all channels and places
active channels into the channel
memory. You can then add or erase
channels as desired by following the
instructions in the "Editing Channel
Memory" section at the right.
3. Repeatedly press MENU until
A UTOPROGRAM is highlighted.
I III
o
Repeatedly press MENU until ED/T
CHANNELS is highlighted. Press + to
select EDIT CHANNELS.
Notes:
• Signals from scrambled cable channels and
some cable channels having unusual signal
conditions may not be autoprogrammed.
• To prevent the TV from losing its channel
memory, make sure the outlet you plug your
TV into is "on" all the time. Do not plug
the 'IV into an outlet that can be turned on
and off by a wall switch. Also do not plug
the TV into an outleton the back of another
device (such as a cable-TV converter box)
that is turned off when the device is turned
off.
• If there is an extended power failure, your
TV will automatically reprograrn active
channels the first time you turn it on after
the power failure.
2rid
SETUP
Menu
4. Press + to begin AutoProgramming.
- The TV cycles through all channels
and places only active channels into
memory.
5. When the TV finishes cycling, you can
check the channels in memory by
pressing CHAN up or down.
2ad
SETUP
Menu
3.
Select the channel number by pressing
CHAN up or down or two number
buttons on the remote.
When "+"appears next to the channel
number, the channel is in the channel
list. Press - to erase the channeL
When "--"appears next to the channel
number, the channel is not in the
channel list. Press + to add the
channel.
4. Press - to erase or press the + to add.
12