Using Advanced Features; Placing Channels In Memory/Autoprogram - GE TV User Manual

Using Advanced Features

Placing Channels in Memory (Autoprogramming)
Only channels 2–13 appear in the TV's memory when you first turn it on.
The channels available in your area must be programmed into the TV's
memory when you hook up your TV. Using CHANNEL up and down
allows you to scan through these channels.
You may want to add or delete a few channels if some stations have weak
signals or were off the air when the TV was programmed. Refer to the Add
or Delete Channels section below.
1.
Place channels in
memory (Autoprogram)
2.
Add or delete channels
20
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogramming
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13
Channel Memory: 13 Stored
Cable/Air: Cable
Controls Alarm Adjust Setup
English Français Español
Autoprogram
Label: 13
Channel Memory: 13 Erased
Cable/Air: Cable
A. Hook up an antenna, cable or
13
components before you begin
these steps or you will not be
able to add channels into
memory.
B. Press MENU•PROG repeatedly
clear
to select the Setup Menu and
highlight Autoprogram. This
menu is white.
C. Press MOVE
15
Autoprogram.
D. Press MOVE
adding all active channels into
memory.
E. Wait until the TV has cycled
through all the channels and
clear
returns to the original channel.
A. Press MENU•PROG repeatedly
13
to select the Setup menu. This
menu is white.
B. Press MOVE
Channel Memory.
C. Press MOVE
clear
channel number.
D. Select the channel number you
want to add or delete with the
number buttons.
13
E. Press MOVE
a channel (you will see Stored
on the screen when added and
Erased when deleted).
F. Repeat D and E for more
channels.
clear
to highlight
to start the TV
to highlight
to underline the
to add or delete