RCA VR354 User Manual page 58

Thomson
Hide thumbs Also See for VR354:
Table of Contents

Advertisement

TROUBLESHOOTING
(CONT.)
Check to make sure the tape is not broken.
Check to make sure the VCR is not in pause mode. Press PAUSE or PLAY to return to normal playback.
Check the ProTect Plus
TM
feature,
REWIND
DOES NOT OPERATE
Check to make sure the tape is not already rewound.
VCR PLUS
SYSTEM
OR TIMER
RECORDING
NOT
MADE
OR WRONG
PROGRAM
RECORDED
Check to make sure the correct VCR Plus+ system code is entered.
Check to make sure the cable box or satellite
receiver was turned on when recording
was to begin.
Check to make sure the program was entered
correctly
(wrong
channel or times).
Power interruption.
Reset the clock.
Check to see if time and date are correct - including
AM/PM.
Check to make sure the program
did not exceed the tape's length or the tape was not rewound
beforehand.
Check to make sure the VCR was turned
off at the time recording
was to start.
Check to make sure there was a tape in the VCR and the cassette's safety tab was intact.
VCR ejects cassette when the end of the tape is reached during
a timer recording.
Check to make sure VCR Plus+ system setup was completed
correctly.
WILL
NOT
RECORD
Check to make sure the safety tab is intact.
Check to make sure the VCR is not in the line mode. Press INPUT on the remote.
INTERNAL
CLOCK
SHOWS
INCORRECT
TIME
OR DATE
Power interruption.
Check to make sure the clock is set accurately
(check AM/PM and date).
Check Daylight-Saving
setting. The clock may have adjusted for daylight-saving
time.
TIME
DID NOT ADJUST
FOR DAYLIGHT-SAVING
TIME
Check to make sure daylight-saving feature isset correctly.
VCR MAKES
NOISE
WHEN
STOPPED
VCR is removing
tape from heads. This is normal. The head cylinder
inside the VCR will continue to rotate for a few
minutes after you put the VCR in the stop mode,
WILL
NOT
AUTO
CHANNEL
SEARCH
ACTIVE
CHANNELS
CORRECTLY
Check to make sure the antenna
connections
are secure and correct.
Check to make sure the Signal Type: CABLE/ANTENNA feature
is set correctly,
(Continued
on next page)
56

Advertisement

Table of Contents
loading

Table of Contents