Table of Contents
Advertisement
TRACKING
Your VCR has automatic
tracking
which removes the streaks
or snow from the picture. Automatic
tracking
is activated
when you insert a tape or turn on the VCR. Occasionally you
may need to manually adjust tracking,
especially if the tape
was recorded
on a different
VCR. Just use the TRACK buttons
to remove the streaks or snow. You can also use tracking
when you pause a tape to reduce jittering
of the picture.
When you manually
adjust the picture, automatic
tracking
is
turned
off. To turn automatic
tracking
back on, press both
TRACK buttons
on the front of the VCR at the same time, or
eject the tape and re-insert it. Tracking has no effect during
recording-_only
playback.
TIME
COUNTER
The time counter
shows the actual time it takes to record a
program
or play back a segment of a recorded tape. It helps
locate the beginning
or end of programs you taped. The time
counter
resets to 0:00:00 whenever
the tape is ejected from
the VCR.
For example,
if you record a 30-minute
program
at the
beginning
of the tape and you want to go to the end of that
program
to begin another
recording,
you would:
1.
Press INFO twice to display the time counter.
2.
Press CLEAR to reset the time counter to 0:00:00.
3.
Press FWD to forward the tape until the time counter
reads 0:30:00.
4.
5.
Press STOR This is the approximate
end of the program.
(You may want to press PLAY to verify.) Now, you can
begin recording
at this spot.
Press INFO twice to remove the time counter from the
screen and return to the normal display mode.
Hours
Minutes
"0:30:00
I
"" Seconds
43
Advertisement
Table of Contents
