RCA CC632 User Manual page 67

Date and/or time
were recorded on
tape
Date and/or time are
incorrect
Error number
(E01, E02, etc.)
appears in
viewfinder
Battery runs down
sooner than
expected
• Displays will be recorded on tape whenever they appear in
the viewfinder. Remove them from viewfinder when
recording. See pages 42-43.
• When AUTO DATE is selected (scene select AE dial in
AUTO), display will automatically be recorded when you
begin recording or change the cassette. Seepages 42-43.
• Clock lithium cell battery may need replacing. Seepage 40.
• Date or time may need to be set. Seepages 41.
Try disconnecting power source. Wait ten seconds and then
connect power source again. If error number does not
disappear from viewfinder, consult your Authorized RCA
Camcorder Servicenter.
If camcorder has not been used for some time, charge the
battery using the REFRESH feature on the adapter/charger.
Battery run times are measured when the camcorder is
recording continuously. You can check your battery by first
fully charging it and then aiming the camcorder at a clock
and recording the picture of the clock. When the recording
stops, play the last recorded section, and note the clock time.
A one-hour battery should give you about 60 minutes of
recording time. In practical use, you may not be able to
record for the full time because the camera uses battery
current when it is waiting between recordings (record-pause
mode) and while you focus and zoom.
65