Table of Contents
Advertisement
[l_l_M/[f#gl"
Trouble
Checks
:-
,
Sometimes
problems can be easily solved by checking a few basic things. Check
below before you call for help or take your TV/VCR to an Authorized
RCA
VCR Servicenter.
Problem
Solution
No power
* Plug TV/VCR into an operating outlet.
• Check connections.
TV/VCR
does not respond toremote
• Aim remote atTV/VCR's remote sensor with no objects b etween them.
• Change batteries.
Poor orno pictureduring TV viewing
• Switch to an active channel.
• Check antenna
connections.
If using supplied
dipole, try adjusting rods.
• Check picture adjustments.
See page 8.
• Make sure the line input is not selected. Press INPUT on the remote to switch
between
audio/video
input jacks and tuner.
No sound
• Press VOLUME up to increase sound.
• Sound has been muted. Press MUTE on remote or VOLUME up.
Snow or streaks
in picture or no picture
during playback
Will not record or play
Cannot insert or eject tape
Time counter not working
Rewind
does not operate
Timer recording
not made
or wrong program
recorded
• Check tape--
it may be worn out or of poor
quality.
Try another tape.
• Some snow/streaks
are normal during search, pause, frame advance, and
slow-motion
playback.
• Press one of the TRACKING buttons on the remote or CHANNEL up or down
on the TV/VCR to move the streaks up or down and out of the picture.
• No cassette in TV/VCR.
• Eject and re-insert cassette.
• Broken tape -- try another cassette.
• Safety tab removed from cassette -- TV/VCR will not record.
• TV/VCR is in pause mode.
Press PAUSE on the remote.
• Insert cassette with window facing up and safety tab facing out.
• To remove cassette, TV/VCR must be connected to working outlet.
• Turn POWER off and then on before trying to insert or remove cassette.
• Press DISPLAY on remote to display
time counter on screen. See page 13.
• The time counter does not advance during unrecorded
portions of tape.
When an unrecorded
segment
of tape is encountered,
the time counter will
hold its count until recorded material is detected again.
• A minus (-) will appear in front of the time counter if you rewind the tape
farther back than a counter reading of 0:00:00.
• Tape already rewound.
• Program
entered incorrectly
(wrong
channel or times). See page 20.
• Cable box was not turned on at time recording was to begin.
• Power interruption.
TIMER indicator
flashes on front of TV/VCR.
• Check to see if time and date are correct -- including
AM/PM.
• Program exceeded tape's length or tape was not rewound beforehand.
• No tape in TV/VCR, or cassette ejected if safety tab broken off.
28
Advertisement
Table of Contents
