Table of Contents
Advertisement
,
4.
Press and release the device button (SAT-CABLE, AUX or 1)V1)) you want to program.
Repeatedly
press and release the ON-OFF
button, watching for the device to respond.
If it does
turn off, press and release the OK button within 3 seconds
to save the code. If you accidentally
passed the code before saving it, press the left arrow button to backtrack through the codes; then
use the right arrow button to go forward through the codes again.
When all codes have been searched, the device button flashes 3 times, then the remote exits manual
code search and returns to normal operation.
Using Automatic
Code Search
1.
Turn on the dc:vic'c you want to control.
2.
On your remote control, simultaneously
press and hold ON-OFF
and MUTE (approximately
3
seconds)
until a device button remains lit. Then release the buttons.
3.
Press and release the device button you want to program.
4.
Press and release the ON-OFF
button once. There is a delay of approximately
6 seconds
before
the remote starts the code search.
The device buttons blinks each time the
remote
control sends a code to
test
for your device.
Keep pointing the remote at the device.
5.
Once the device turns off, quickly press the OK button to save the code.
6.
If you accidentally
passed the code before saving it, press the left arrow button to backtrack
through the codes; then use the right arrow button to go forward through the codes again.
When all codes have been searched, the device button flashes 3 times, then the remote exits
automatic
code search and returns to normal operation.
How to Use the Remote
After
You've
Programmed
It
Once the remote has been programmed
succ'essfldly, you arc: ready to use it to operate
your devices.
To Operate the Device:
1.
Press the appropriate
device button (SAT-CABLE, AUX, DVD) to set the remote to control the
device.
2.
Press ON-OFF
to turn the device ON or OFF.
3.
Use the remote buttons that apply to that device.
Notes: The remote control may not be compatible with all brands and models of devices.
Some of the remote buttons might operate differently for other devices, especially when you're
using another device's menu system.
Modes of Operation
Because this tmiversal
lC?ll]{}tc? ('an c'ontrol
sevcral
different devices (DVD
player,
VCI L c'ablc
box,
etc.) it uses operational
modes triggered
by the device buttons. For example, if you want the remote
control to operate the T_, press the TV button to put the remote into TV mode. If you want the
remote to operate the DVD player, press the DVD button.
The button corresponding
to the mode the remote is in lights up when you press aw button that
works in that mode. For example, if you're in TV mode and you press the VOL+ button, the TV
button lights up. This tells you that the command
to increase the volume is being sent to the TV (and
not the satellite receiver, for example).
Chapter2
25
Advertisement
Table of Contents
