Table of Contents
Advertisement
Volume
Punchthrough
Feature
You may find this feature hdpful
if" you've connected
an audio/video
receiver (A/V receiver) or amplifier, and you want to
use the TV's remote control to operate
the volume for a device that is connected
to the audio/video
receiver, An example
follows:
Let's say you've connected
your DVD player to your audio/video
receiver. You've also programmed
your TV remote control to
operate your DVD player. Since the DVD player sends its volume through the audio/video
receiver, you would have to bounce
back and forth between two remote controls: the A/V receiver's remote to adjust the volume and the TV's remote control to
operate the DVD player.
The Volume Punchthrough
feature eliminates the need for you to use two remote controls and saves a button press when
you're using the TV remote to adjust the volume. In effect, you are telling the TV remote to retrieve and send volume
commands
from the AiV receiver whenever
the TV remote is in DVD mode.
Therefore,
after you've
successflllly
set up the Volume
Punchthrough
feature,
whenever
the TV remote
is in DVD mode
(press
the DVD button)
and you want
to adjust
the volume,
you only have to press
the VOL +, VOL- or MUTE buttons.
Follow
the instructions
below
to
set
up Volume
Punchthrough.
IMPORTANT." First, you must program
a device button
(SAT.CABLE, DVD, AUX) on the Tg's remote control
to operate your
audio receiver or amplifier.
Go to page 24 for instructions.
If you can't program
this remote to operate your audio receiver,
Volume Punchthrough
won't
work.
While setting
up Volume Punchthrough,
it's best to point the remote away from other devices.
1.
On your
remote
control,
simultaneously
press
and hold
the ON-OFF
and MUTE buttons
(approximately
3 seconds)
until a device
button
remains
lit. Then
release
the buttons.
2.
Press and hold the MUTE button until the device button blinks off, then release the MUTE button.
3.
Press and release the device button that you programmed
to operate
the audio device (receiver or amplifier).
4.
Press and release the MUTE button.
5.
Now, test it by turning on your audio system.
6.
Turn on the device that is connected
to the audio system (a satellite receiver, for example).
7.
Put the TV's remote in SAT mode by pressing the SAT-CABLE button.
8.
The volume from the audio system should increase or decrease
when you press the VOL+ or VOL- buttons.
Deleting
ALL Volume
Punchthrough
Commands
To ddcte all
programmed
Volume Punchthrough settings and
return
the remote control back
to the factory
defaults:
1.
Simultaneously
press and hold the ON-OFF
and MUTE buttons (approximately
3 seconds)
until a device button lights.
2.
Rdease the ON-OFF
and MUTE buttons (the device button stays lit).
3.
Press and hold the MUTE button (approximately
3 seconds)
until the device button blinks off, then release the MUTE
button.
4.
Press and release the MUTE button (the device button light turns off).
5.
The remote returns to normal operation
and Volume/Mute
control.
26
Advertisement
Table of Contents
