Screen Configuration; Setting The Day Of The Week And Time; Operation - Mitsubishi Mr.Slim PKA-A18HA Operation Manual

3. Screen Configuration
Function Selection ofremote controller
Set Day/Time
Standard Control Screens
OFF ON
Timer Monitor Timer Setup
T,_, j,_, ..... , I iT,%%,,_ i _v_:_':'_ ........
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
® Function Selection of remote controller:
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
• Set Day/Time: Set the current day of the week or time.
• Standard Control Screens:
View and set the air conditioning system's op-
erating status
• Timer Monitor: View the currently set timer (weekly timer, sim-
ple timer, or Auto Off timer)
• Timer Setup: Set the operation of any of the timers (weekly
timer, simple timer, orAuto Off timer).
<How to change the screen>
@ : Hold down both the Mode button and the Timer On/Off button for 2
seconds.
® : Press the Timer Menu button.
© : Press the Mode (Return) button.
® : Press either of the Set Time buttons (V or/k).
4. Setting the Day of the Week and Time
_ TE_4P (_ ON/OFF
[3 d3-----
[] [] Day of the Week Setting
Day of the Week /
& Time display [] Time Setting
@
Note:
The day and time will not appear if clock use has been disabled at Function
Selection of remote controller,
1. Press the V or/k Set Time button @ to show display %.
2. Press the Timer On/Off (Set Day) button @ to set the day.
* Each press advances the day shown at %: Sun _ Mon ..... Fri
Sat.
3. Press the appropriate Set Time button @ as necessary to set the time.
*As you hold the button down, the time (at %) will increment first in
minute intervals, then in 10-minute intervals, and then in 1-hour inter-
vals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button @ to lock in the values.
5. Operation
[]
@
[]
[]
[]
[]
5.1. Turning ON/OFF
<To Start Operation>
[] Press the ON/OFF button ®.
• The ON lamp [] and the display area come on.
%
.®
.@
.©
<To Stop Operation>
[] Press the ON/OFF button ® again.
• The ON lamp [] and the display area go dark.
Note:
Even if you press the ON/OFF button immediately after shutting down the op-
eration is progress, the air conditioner will not start for about three minutes,
This is to prevent the internal components from being damaged.
5