Table of Contents
Advertisement
Chapter
4. TV Menu
Settings
49
Channel Menu
II
IL
Settings
for the Channel
mory
Number
Shown
Signal-Strength
indicator
(digital
channels
only}
Figure 7. Channel menu
Antenna
(Channel
Menu)
Select either 1 (ANT 1 MAIN)
or 2 (ANT 2 AUX) as the
antenna source for the channels you wish to edit.
Channel
(Channel
Menu)
Select the channel number affected by this menu in any of
three ways:
•
Press _, Y to move through all channel numbers, one
at a time. If you also wish to tune to the channel,
highlight the channel number and press ENTER.
Press CB/x/V
to select from channels already in
memory.
If you also wish to tune to the channel, high-
light the channel number and press ENTER.
Enter the number directly and press ENTER. Note that
with this method, you must press ENTER for the screen
to display settings for the selected channel.
Channel numbers can be one part, analog or digital (up to
the number 16383), or two part for digital channels.
For
a two-part
digital channel, press _
on the remote to
enter a separator after the first, second, or third number,
depending on the broadcaster's
channel information.
For digital channels, when the broadcaster
has sent a
virtual channel number, the virtual channel number is
shown in the text box and the original physical digital
channel is shown below on screen as a reference.
One
original channel number can be associated with several
different virtual channels.
Memory
(Channel
Menu)
After the available channels have been memorized with
Memorize
Channels
on the Setup menu, you can add
weaker channels or delete unwanted channels using this
option.
For example, if you wish to see only digital chan-
nels listed, use this menu to delete analog channels from
memory.
Press CR/_/V
to review the channels in memory.
Press
A 'V' to select Added or Deleted for the channel shown in
the Channel box.
Name
Analog channels from ANT
I and ANT 2 can be named
with up to four characters.
The name you enter here will
appear on the TV screen as part of the on-screen status
display.
Digital channels may already be named if the
broadcaster
sends the information.
1.
Press a number key repeatedly to cycle through the
characters associated with the key. You can also use
A V to change a highlighted character.
2.
Press ENTER to set the letter and move to the next letter
position.
Press CANCEL to move back one position.
Signal
Strength
(Channel
Menu)
Displays the approximate
signal strength of the currently
tuned digital channel.
Use this indicator to help you
adjust the antenna direction for best signal reception.
The taller the bar, the stronger the signal. This indicator
applies only to digital channels.
To view the effects of antenna adjustments
on digital
channels, tune to the digital channel you wish to measure
while remaining in this menu. To tune to a channel, either:
Highlight the channel box, press ON/%/V
or A Y to
display the desired channel number, and press ENTER.
Enter the channel number on the remote control and
press ENTER.
Hide quick links:
Advertisement
Table of Contents
