Audio/Video Menu - Mitsubishi Electric DLP WD-52631 Owner's Manual

Chapter 4. TV Menu Settings 57
Audio/Video Menu
Figure 13. Audio/Video Menu
A/V Memory Reset
A/V Memory Reset allows you to reset a specific input's
A/V settings to the original factory settings. Highlight the
box and press A. V to select the input name. Next press
ENTER.
The audio settings of Balance, Listen to, and Language
are general TV settings unaffected by A/V Memory Reset.
To reset all A/V settings at once, including the three
general settings, perform an A/V Reset by pressing the
front-panel buttons GUIDE a nd FORMAT simultaneously.
{Audio and Video)
Each input or device has its own A!V memory. Press A
Y to select the input or device in the A/V Memory Reset
box, then select Audio or Video to adjust individual
settings. Press ENTER to close the menu and display the
individual settings.
Use A V to cycle through the individual settings. Use
_ to change the setting values. Press EXIT to return to
normal TV viewing. For descriptions of the individual A/V
settings, see the following pages.
Video Mute
The default is On, which displays a blue background when
no signal is being received on the INPUT, COMPO=
NENT, or HDMI jacks.
Film Mode (480i signals only)
Auto is the default setting. With Auto selected, the TV
automatically detects and applies film-decoding correc-
tion for images that originated on 24-frame-per-second
film cameras and were converted to 30-frame-per-second
video for broadcast (3:2 pulldown conversion). Try the
Off setting if the TV adds noticeable jagged edges to the
images.
When the original video was filmed on 30-frame-per-
second cameras, the Auto setting automatically applies
video decoding, the same as used with the Off setting.
Film Mode is not effective for high-definition signals.
TV Speakers
This selection turns the TV's internal speakers on or off.
Select Off when sending the sound through a separate
stereo system or surround sound A/V receiver.
Note: To prevent damage from a sudden increase in vol-
ume, turn the TV volume down low before chang-
ing this option to On.
Audio/Video Settings and the Remote Control
To adjust individual audio or video settings directly with
the remote control:
1. Press AUDIO or VIDEO repeatedly to cycle through the
available settings.
2. Press 4 _ to adjust the setting. The setting display
will disappear after five seconds of inactivity.