Section 2 -- Option Menu And Service Adjustment Mode; Option Menu; Service Adjustment Mode - Mitsubishi Electric VS-45605 Technical Training Manual

Option Menu and Service Adjustment items must be set to either a specific setting, data value or set accord-
ing to a prescribed adjustment procedure. For specific adjustment instructions, refer to the Service Manual.
For training purposes, the Option Menu setup and Service Adjustment procedures are reprinted from the
Service Manual.

1. Option Menu

Option Menu items should be set as shown in the figure below. The Initial function is also accessed from the
Option Menu. Performing an Initial setup will set all customer controls to the factory default condition. This
can be useful in determining if a symptom is caused by an improperly set customer control.
Follow the steps below for the Initial set-up:
1. Select the "MENU" display by pressing the "MENU" button once.
2. Press the number buttons "1", "2", "7", "0" in sequence to select the "OPTION MENU" display.
3. Press the "ADJUST" button to select "INITIAL."
4. Press "ENTER."
NOTE:
CAUTION: On these models E2 RESET activation has been changed. To activate,
Section 2
Option Menu

Service Adjustment Mode

At this time channel 3 is automatically selected.
the "QV" button must be pressed while "E2 RESET" is selected on the menu
screen. The "QV" button may be denoted as "RCL" on some models.
This feature is for factory use only. DO NOT ACTIVATE E2 RESET AS
THIS WILL RESET ALL ALIGNMENT DATA. Doing so will require a full item by item
alignment of all data values listed in the "adjustment items" section
of this manual.
OPTION MENU
INITIAL
E2 RESET
POWER RESTORE:
WHEN MUTE:
DIRECT KEY MODE
VS-70705
V-CHIP
SERIES SETTING:
SERIES SETTING:
*This option should be "YES" for model VS-70705
and
OFF
ON
OFF
*NO
ON
XXXXXXXX
XXXXXXXX
Page 2-1