Table of Contents
Advertisement
MVX 128 A VGA Matrix Switchers, continued
RGBHV and Audio buttons select/deselect
video and/or audio. The Audio LED blinks
to indicate audio breakaway. The Audio
button also selects the audio level/adjust
mode. See Viewing and adjusting the audio level
in the next column.
Create a tie
1. Press and release the Esc
button to clear any input
LEDs, output LEDs, or
control LEDs that may be
lit.
2. Press and release the
RGBHV and/or Audio
I/O button(s) to select or
deselect video and/or audio as desired.
I/O
Lit when selected.
Off when deselected.
RGBHV AUDIO
3. Press and release the
desired input button.
4. Press and release the
desired output button(s).
Output LEDs blink to indicate a potential tie.
3
4
Enter LED blinks to indicate the
need to confirm the change.
5. Press and release the Enter button. All input
and output LEDs and the Enter LED go out.
Saving or recalling a preset
1. Save a preset — Press and hold the Preset
button for 2 seconds.
Recall a preset — Press and release the Preset
button.
MVX 128 A VGA Matrix Switchers • Quick Start
QS-2
Quick Start —
Press the Esc button
to clear all selections.
ESC
The LED blinks once.
Lit when selected.
Off when deselected.
5
The input LED
lights to indicate
the selection.
ENTER
8
Save a
Press and hold.
preset
2 seconds
PRESET
Preset LED blinks.
Recall a
Press and release.
preset
PRESET
Preset LED lights.
All input and output buttons with assigned presets light.
The configuration data at assigned preset
locations will be overwritten.
1
2
3
2. Press
1
The LED blinks to indicate that this preset
and
is selected.
release
the
desired
input or
output button.
3. Press and release the Enter button.
Viewing and adjusting the audio level
1. Press and hold the
Audio button.
2. Press an input or
output button. See
chapter 3 to read the
displayed value.
5
Press an input button to adjust gain/attenuation.
— or —
Press an output button to adjust the output volume.
1
2
3
3. Increase and
button
decreases
decrease
the level.
the gain/
attenuation or
volume level
by pressing
>
<
the Esc (
) and View (
4. Press and release the Audio button to exit.
PRESET
PRESET
4
5
The Enter LED
blinks to indicate
the need to save or
ENTER
recall the preset.
Audio LED blinks.
Hold
2 seconds
AUDIO
AUDIO
Output LEDs display
gain/attenuation.
— or —
Input LEDs display
output volume level.
4
OUTPUTS
button
increases
the level.
VIEW
ESC
) buttons.
Advertisement
Table of Contents
