Electronic Clock And Oven Control - Maytag CRE9900ACB Owner's Manual

RANGE CONTROL PANEL
ELECTRONIC CLOCK AND OVEN CONTROL
The electronic clock and oven control on your
Maytag range is used for the time-of-day doek,
timer, bake, broil, delay' start and self-clean
functions. A beep will sound each time a
fimetion pad is pressed. At the end of an
operation, consecutive beeps will sound,
The display on the control will blink when power
is first supplied to the range or if there is a power
t_ailure. Once the time-of-day clock has been set
(see Setting the Clock, page 6), the display will
stop blinking.
NOTE: Theeleetronicecmtr61:iS:eq@ped :;
u4th a self-diagnostic feature::tbr se_ee use: :
ONLY. tf a fault :eX:::F:t):
appears in the display alongwith a Continu0uS
beeping sound, press the C_CEL
Before You Cal! for Service (page 24)if:the ::
faut t code reappear s in _he:d!sp!a_ :_ :::::.. : :
The following pads and knobs are found on your
Ma)_ag electronic rAoek and oven control:
Cancel Pad
Press this pad to cancel all operations except the
time-of-day clock and timer. If you are ever
unsure if you've programmed the control
cx)rrectly; press the CANCEL pad and start over.
Set Knob
Turn this knob in either direction to enter the
time or temperatm-e desired. This knob is also
used to select Hi or Lo broil.
Timer Pad
The timer can be set from 5 seconds to 9 hours,
50 minutes, It x_41I count do_aa by minutes (when
set for 1 hour or inore time) or seconds (when
set tbr less than I hour). See page 6 for
instructions on setting the timer.
Clock Pad
Use this pad to set the time-of-day clock. For
instructions to do this, see page 6.
PAGE 5