Maytag MVWX5SPAW0 Use And Care Manual page 11

Top-loading high efficiency low-water
Table of Contents

Advertisement

Available languages

Available languages

WINTER
STORAGE
CARE
IMPORTANT:
To avoid damage, install and store washer
where it will not freeze. Because some water may stay in
hoses, freezing can damage washer. If storing or moving
during freezing weather, winterize your washer.
To winterize
washer:
1. Shut off both water faucets, disconnect
and drain water
inlet hoses.
2. Put 1 qt. (1 L) of R.V.-type antifreeze in basket and run
washer on ENJUAGAR & EXPRIMIR (Rinse & Spin) cycle
for about 30 seconds to mix antifreeze and remaining
water.
3. Unplug washer or disconnect
power.
NON-USE
AND VACATION
CARE
Operate your washer only when you are home. If moving, or
not using your washer for a period of time, follow these steps:
1. Unplug or disconnect
power to washer.
2. Turn off water supply to washer, to avoid flooding
due to water pressure surge.
TRANSPORTING
YOUR WASHER
1. Shut off both water faucets. Disconnect
and drain water
inlet hoses.
2. If washer will be moved during freezing weather, follow
WINTER STORAGE CARE directions before moving.
3. Disconnect
drain from drain system and drain any
remaining water into a pan or bucket. Disconnect
drain
hose from back of washer.
4. Unplug power cord.
5. Place inlet hoses and drain hose inside washer basket.
6. Drape power cord over edge and into washer basket.
7. Place packing tray from original shipping materials back
inside washer, if you do not have packing tray, place heavy
blankets or towels into basket opening. Close lid and place
tape over lid and down front of washer. Keep lid taped until
washer is placed in new location.
r
RE! NSTALLING/USI
NG WASHER
AGAI N
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to "Installation
Instructions" to locate, level, and
connect washer.
2=
Before using again, run washer through the following
recommended
procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2=
3.
Plug in washer or reconnect power.
Run washer through LLENADO COMPLETO (Bulky) cycle
to clean washer and remove antifreeze, if used. Use only
HE High Efficiency detergent. Use half the manufacturer's
recommended
amount for a medium-size
load.
11

Advertisement

Table of Contents
loading

Table of Contents