Starting Your Washer - Maytag MVWX700XL2 Use And Care Manual

"7, Select cycle
with,
rinse
drain &spin
&spin
estimated time
remaining
Turn cycle knob to choose your wash
cycle. The indicator for Estimated Time Remaining will light up
with a cycle time. For more information, see "Control Panel".
8, Select cycle modifiers
Q hot Q extra heavy
Q warm Q heavy
Q cool Q medium Q high
Q cold Q reed light Q low
Q tap cold Q light Q no spin
modifiers
Once you select a cycle, the default settings for that cycle
will be lit. Press the cycle modifiers buttons to change the
Temperature, Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care labels instructions
to avoid damage to your garments.
Wash Temp Suggested Fabrics
Not ::
Some cold water is added to save ::iWhites and pastels
energy. This may be cooler than ::iDurable garments
your hot water heater setting. Heavy soils
Some cold water will be added,
so this may be cooler than what
Moderate to light soils
Cool - brights/darks
Warm water is added to assist
in soil removal and to help
dissolve detergents.
Colors that bleed
or fade
Tap Cold
This is the temperature from Dark colors that
your faucet, bleed or fade
Light soils
9, Select cycle options
hi .low,off
options
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as Prewash or Extra Rinse. These can be turned
off, if desired.
NOTE: Not all options are available with all cycles.
1 0, Select START/Pause/Unlock to
begin wash cycle
start
G
pause
unlock
Press START/Pause/Unlock button to start the wash cycle.
Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the DONE indicator
will light and the end of cycle signal will sound (if set).
Promptly remove garments after cycle has completed to
avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps.
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed garments:
Press START/Pause/Unlock; the lid will unlock once the
washer movement has stopped. This may take several
minutes if the load was spinning at high speed. Then close
lid and press START/Pause/Unlock again to restart the cycle.
If lid is left open for more than 10 minutes the water
will pump out.
Delay in water fill
Fillling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.