Troubleshooting - Maytag MVWX700XL2 Use And Care Manual

Top-loading high efficiency low-water washer
Table of Contents

Advertisement

Available languages

Available languages

RE! NSTALLING/USI
NG WASHER
AGAI N
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended
procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet hoses.
Turn on both water faucets.
Electrical
Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result
in death,
fire, or electrical
shock.
2=
3.
Plug in washer or reconnect power.
Run washer through BULKY cycle to clean washer and
remove antifreeze, if used. Use only HE High Efficiency
detergent. Use half the manufacturer's
recommended
amount for a medium-size
load.
Check the following for
proper installation or
see "Using Your
Washer" section.
TROUBLESHOOTING
First try the solutions suggested here or visit our website to possibly avoid the cost of a service call ...
In USA www.maytag.com/help
- In Canada www.maytag.ca.
Feet may not be in contact with the
Front and rear feet must be in firm contact with floor, and
floor and locked,
washer must be level to operate properly. Jam nuts must be
Washer may not be level.
Load could be unbalanced.
Objects caught in washer drain
system.
Clicking or metallic
noises
Gurgling or humming
Washer may be draining water.
Humming
The sensing light is on.
tight against the bottom of the cabinet.
Check floor for flexing or sagging. If flooring is uneven, a 3/4"
(19 mm) piece of plywood under your washer will reduce sound.
See "Level the Washer" in Installation Instructions.
Load garments in loose heaps evenly around the washplate.
Do not load garments directly over the center of the washplate.
Adding wet items to washer or adding more water to basket
could unbalance washer.
Wash smaller loads to reduce imbalance.
Use Bulky cycle for oversized, non=absorbent items such as
jackets and small comforters.
See "Cycle Guide" and "Using Your Washer" in this Use and
Care Guide.
Empty pockets before washing. Loose items such as coins
could fall between basket and tub or may block pump.
It may be necessary to call for service to remove items.
It is normal to hear metal items on clothing such as metal snaps,
buckles, or zippers touch against the stainless steel basket.
It is normal to hear the pump making a continuous humming sound
with periodic gurgling or surging as final amounts of water are
removed during the spin/drain cycles.
You may hear the hum of the sensing spins after you have started
the washer. This is normal. Sensing spins will take several minutes
before water is added to the washer,
j
11

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mvwx700ag0Mvwx700xw2Mvwx600xw2

Table of Contents