Advertisement
Other
Hints
on
Caring
for Your
Oven
Cleaning
Other
Surfaces
of Your
Oven
Door
and
control
panel
trim:
The metal trim around
the door and the control
panel can be cleaned
with
any non-abrasive
cleansers
such as Bon Ami or soapy
water;
rinse well. Be careful
not to use an excessive
amount
of water.
Glass
on the
control
panel
front
and
oven
door
front:
To clean, use any
suitable
glass cleaner
or soapy
water.
Spray glass cleaner
then wipe the panel.
NOTE:
When wiping
the panel there is a possibility
of entering
or changing
settings
of the oven control.
Oven
Light
Bulb
Before
replacing
bulb, disconnect
power
to oven at the main fuse or circuit
breaker
panel
Be sure that the entire
oven
cavity
including
the light
bulb
is cool
before
attempting
to remove.
To replace
light
bulb:
1. Carefully
remove
the glass light lens and lens
retainer
by removing
the two screws in the light
lens retainer using a phillips screwdriver. Note: The
light lens is separate from the light lens retainer.
The two pieces will drop down into your hands at
the same time. Do NOT remove the remaining two
screws.
2. To
obtain
firm
grasp on bulb,
wear
protective
rubber gloves. Remove by turning bulb to the left.
Do not touch a hot oven light bulb with a damp
cloth as bulb will break.
Note: If the bulb does
break and you wish to remove it, be certain power
supply is disconnected
and wear protective gloves.
You may contact your authorized
Maytag Service
Technician
for service.
.
=
Replace
bulb with a 40 watt oven-rated
appliance
bulb.
Bulb
with
brass
base is recommended
to
prevent fusing
of bulb into socket.
Place light lens inside of light lens retainer.
Hold-
ing the light lens and lens retainer
in place, insert
the two screws
into the
light
lens
retainer
and
tighten.
31
Advertisement
